mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2826 > < Initial Inspection and Diagnostic Overview|Page 2824
Page 132
background image

-

Voltage should be approximately 12 volts (battery positive voltage).
If one of the checks above does not show approximately 12 volts, go to Step 5.
If both of the checks above show approximately 12 volts, go to Step 7.

STEP 5. Check the theft-alarm horn relay connector A-11X for damage.

If the theft-alarm horn relay connector A-11X is damaged, repair or replace it. Refer to Harness Connector Inspection.

The answerback function should work normally.

If the connector is in good condition, go to Step 6.

Initial Inspection and Diagnostic Overview|Page 2826 > < Initial Inspection and Diagnostic Overview|Page 2824