Galant ES L4-2350cc 2.4L SOHC MFI (1997)
Step 1: Negative (-) Battery Cable Disconnection
Disconnect the negative battery cable from the battery and tape the terminal.
CAUTION: Wait at least 60 seconds after disconnecting the battery cable before doing any further work.
Step 4: SRS-ECU Installation
CAUTION: The SRS may not activate If SRS-ECU Is not Installed properly, which could result in the SRS system not operating properly In a
collision.
Post Installation Inspection
1. Turn the ignition key to the 'ON" position.
2. Does the "SRS" warning light illuminate for about 7 seconds, and then remain off for at least 5 seconds after turning off?
3. It yes, SRS system is functioning properly. If no, Refer to Post-Collision Diagnosis.
INSPECTION
-
Check the SRS-ECU case and brackets for dents, cracks or deformities.
-
Check connector for damage, and terminals for deformities.
CAUTION: If a dent, cracks, deformation or rust Is discovered, replace the SRS-ECU with a new one.
NOTE: For checking of the SRS-ECU other than described above, refer to the section concerning troubleshooting.