Galant LS V6-3.0L SOHC (1999)
should work normally.
If the connector is in good condition, go to Step 3.
STEP 3. Check the harness wires between ETACS-ECU connector C-86 and ignition switch (IG1).
NOTE: After checking junction block connector C-73, check the wires. If junction block connector C-73 is damaged, repair or replace it. Refer to
Harness Connector Inspection.
If the harness wires between ETACS-ECU connector C-86 and ignition switch (IG1) are damaged, repair them.
The ignition switch (IG1) input signal should be able to be checked and the functions, which are described in the "Technical Description (comment),"
should work normally.
Inspection Procedure N-3