mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 3209 > < Initial Inspection and Diagnostic Overview|Page 3207
Page 222
background image

STEP 3. Check trunk lid lock key cylinder switch connector F-22 for damage.

If the trunk lid lock key cylinder switch connector F-22 is damaged, repair or replace it. Refer to Harness Connector Inspection.

The input signal from the trunk lid lock key cylinder switch should be able to be checked and the theft-alarm system should be armed.

If the connector is in good condition, go to Step 4.

STEP 4. Check the harness wires between trunk lid lock key cylinder switch connector F-22 and ground.

NOTE:  For 1999 models, after checking intermediate connector F-16, check the wires. If intermediate connector F-16 is damaged, repair or replace it.
Refer to Harness Connector Inspection.

If the harness wires between trunk lid lock key cylinder switch connector F-22 and ground are damaged, repair them.

The input signal from the trunk lid lock key cylinder switch should be able to be checked and the theft-alarm system should be armed.

STEP 5. Check the trunk lid lock key cylinder switch connector F-22 and ETACS-ECU connector C-81 for damage.

If the trunk lid lock key cylinder switch connector F-22 and ETACS-ECU connector C-81 are damaged, repair or replace them. Refer to Harness
Connector Inspection. The input signal from the trunk lid lock key cylinder switch should be able to be checked and the theft-alarm system should be

Initial Inspection and Diagnostic Overview|Page 3209 > < Initial Inspection and Diagnostic Overview|Page 3207