Galant LS V6-3.0L SOHC (1999)
1. Take special tool MB628919 or MR203491 that is connected to the wires, pass it beneath an old tire wheel assembly, and connect it to the air
bag module.
CAUTION: The deployment wires below the wheel should be loose. If it is too tight, the reaction when the air bag deploy could damage
special tool MB628919 or MR203481.
2. Pass the thick wire through the air bag module mounting hole, and then secure the air bag module to an old tire with a wheel in it so that the
pad on the module is facing upwards.
3. Place three old tires without wheels on top of the tire secured to the air bag module.
WARNING:
1. Before deployment, check carefully to be sure that no one is nearby.
2. The inflator will be quite hot immediately following the deployment, so wait at least 30 minutes to allow it to cool before
attempting to handle it. Although not poisonous, do not inhale gas from air bag deployment. See Deployed Air Bag Module
Disposal Procedures for post-deployment handling instructions.
3. If the air bag falls to deploy, do not go near the module. Contact the MMSA Tech Line.
5. At a location as far away from the air bag module as possible, and from a shielded position, disconnect the two connected wires from each other,
and connect them to the two terminals of the battery (which has been removed from the vehicle) to deploy the air bag.
6. After deployment or operation, remove the side air bag module from the seatback and then dispose it according to the Deployed Air Bag Module
Disposal Procedures.
Passenger Air Bag Module
Before disposing of an air bag or a vehicle equipped with an air bag, follow the procedures below to deploy the air bag.
Required Special Tools:
MB628919 or MR203491 : SRS Air Bag Adapter Harness B
MB686560
: SRS Air Bag Adapter Harness A
MR372530
: SRS Air Bag Adapter Harness
WARNING:
1. If the vehicle is to be scrapped or otherwise disposed of, deploy the air bags inside the vehicle. If the vehicle will continue to be used and