Lancer L4-2.0L (4B11) (2008)
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary.
STEP 7. Check combination meter connector C-04 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is combination meter connector C-04 in good condition?
YES : Go to Step 8.
NO : Repair or replace the damaged component (Refer to general (electrical), Harness Connector Inspection ). The steering remote control switch
should work normally.
STEP 8. Check the wiring harness between combination meter connector C-04 (terminal 23) and clock spring connector C-205 (terminal 6).
-
Check the power supply lines.
Q: Is the wiring harness between combination meter connector C-04 (terminal 23) and clock spring connector C-205 (terminal 6) in good condition?
YES : Go to Step 9.
NO : The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary.
STEP 9. Retest the system
Check whether the illumination of the steering remote control switch comes on normally.
Q: Doe the illumination of the steering remote control switch comes on normally?
YES : The trouble can be an intermittent malfunction (Refer to general (Body and Chassis), How to use Troubleshooting/inspection Service
Points, How to Cope with Intermittent Malfunction).
NO : Replace the steering wheel voice-control switch.
Inspection Procedure 7
This document has been updated per Mitsubishi TSB #07-54-005
Inspection Procedure 7: Check the hands-free-ECU power supply circuit.
CAUTION: Before replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.