Lancer L4-2.0L (4B11) (2008)
1. Install the camshaft bearing caps to the cylinder heads.
NOTE: Because the thrust camshaft bearing cap and cam shaft bearing cap are the same in shape, check the bearing cap number and additionally
its symbol to identify the intake and exhaust sides for correct installation.
2. Tighten each camshaft bearing cap mounting bolt to the specified torque in the order of number shown in the figure in two or three steps.
Tightening torque: 12 ± 1 Nm (106 ± 9 in-lb)
]]E[[ FRONT CAMSHAFT BEARING CAP ASSEMBLY INSTALLATION
CAUTION
When the mounting bolts are tightened with the front camshaft bearing cap tilted, the front camshaft bearing cap is damaged. Install the
front camshaft bearing cap properly to the cylinder head and camshaft.
1. Install the front camshaft bearing cap to the cylinder head, and temporarily tighten the front camshaft bearing cap to the specified torque in the
order of the figure (1).
Tightening torque: 17 ± 3 Nm (13 ± 2 ft-lb)
2. Tighten the front camshaft bearing cap again to the specified torque in the order of the figure (2).
Tightening torque: 30 ± 2 Nm (22 ± 1 ft-lb)
]]F[[ FUEL HIGH-PRESSURE HOSE INSTALLATION