Lancer L4-2.0L (4B11) (2008)
CAUTION:
-
If the center of the clock spring is not correctly aligned, the steering wheel may not be turned fully or the cable inside the clock spring
may be broken, causing the SRS air bag to be inoperative or operated incorrectly.
-
When aligning the clock spring neutral position mark, perform with the clock spring independently. If performed with the steering
wheel sensor installed, the steering wheel sensor may be damaged.
2. Align the mating marks of the clock spring. Alignment of mating marks
1. Turn the clock spring clockwise fully.
2. Turn the clock spring counterclockwise approximately three and 3/4 turns to align the mating marks.
3. Install the clock spring to the column switch.
]]C[[ STEERING WHEEL ASSEMBLY/DRIVER'S AIR BAG MODULE ASSEMBLY INSTALLATION
CAUTION: When installing the steering wheel and air bag module, ensure that the harness of the clock spring does not become caught or
tangled.
1. Before installing the steering wheel and air bag module, turn the vehicle s front wheels to the straight-ahead position and align the mating marks of
the clock spring.
2. After securing the steering wheel, turn the steering wheel all the way in both directions to confirm that the steering wheel rotation is normal.
]]D[[ driver's AIR BAG MODULE CONNECTOR/HORN CONNECTOR CONNECTION
Connect the connector securely and route the harnesses not to lie off the cover hole.
]]E[[ POST-INSTALLATION INSPECTION
1. Reconnect the negative (-) battery cable.
2. Turn the ignition switch to ON position.
3. Does the "SRS" warning light illuminate for approximately seven seconds, and go out?
4. If yes, the SRS system is functioning properly. If not, refer to DIAGNOSTIC TROUBLE CODE CHART <SRS-ECU>.
Inspection
INSPECTION
AIR BAG MODULE CHECK
DANGER : Never attempt to measure the circuit resistance of the air bag modules (squib), even if you are using the specified tester. If the
circuit resistance is measured with a tester, accidental air bag deployment will result, and possible serious personal injury.
WARNING: If any component damage is found during the following inspection, replace the air bag module with a new one. Dispose of the old
according to the specified procedure.