Lancer L4-2.0L (4B11) (2008)
If any malfunction is found in the following inspections, replace the clock spring with a new one.
1. Check the connectors and protective tube for damage, and the terminals for deformation.
2. Visually check the case for damage.
3. Check to see that there is a charge (continuity) between the C-205 clock spring connector terminal 1 and C-206 horn switch.
CAUTION: Do not directly insert a probe, etc. into the terminal from the front of the connector.
4. Insert the special tool MB992006 from behind the airbag module connector of the C-207 driver's side.
5. Connect the circuit tester to the special tool as shown in the figure, and check the continuity among terminal No. 1-2 and No. 3-4.