Lancer L4-2.0L (4B11) (2008)
Cross-Member: Service and Repair
Engine Roll Stopper and Centermember
ENGINE ROLL STOPPER AND CENTERMEMBER
REMOVAL AND INSTALLATION
CAUTION
^
The part indicated by the *1 mark should be temporarily tightened, and then fully tightened with the engine and transaxle assembly
weight applied on the vehicle body.
^
The parts indicated by the *2 are the bolts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and
soiling from bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal & Post-installation Operation
Front Roll Stopper and Centermember Removal Steps 1-6 / Rear Roll Stopper Removal Steps 7-8
INSTALLATION SERVICE POINT
]]A[[ FRONT ROLL STOPPER INSTALLATION