Lancer L4-2.0L (4B11) (2008)
Pull out the selector lever knob to the direction of arrow shown in the figure.
INSTALLATION SERVICE POINTS
]]A[[ TRANSAXLE CONTROL CABLE (TRANSAXLE SIDE) INSTALLATION
1. Move the selector lever and manual control lever to the "N" position.
2. Use the adjusting nut to tighten the transaxle control cable to the specified torque.
Tightening torque: 9.5±3.5 Nm (84±31 in-lb)
]]B[[ KEY INTERLOCK CABLE INSTALLATION
CAUTION
Leave the ignition switch in the "LOCK" (OFF) position until the key interlock cable installation is completed.
1. Move the selector lever to the "P" position and turn the ignition switch to the "LOCK" (OFF) position.