Lancer L4-2.0L (4B11) (2008)
/Page-1784001.png)
Wiper Motor: Testing and Inspection
Windshield Wiper Motor At Stop Position Operation
WINDSHIELD WIPER MOTOR AT STOP POSITION OPERATION
1. Connect the battery to the windshield wiper motor as shown in the illustration (A).
2. Run the windshield wiper motor at low speed, then disconnect the battery in the middle of the motor rotation and check to see that the motor stops.
3. Connect the battery to the windshield wiper motor as shown in the illustration (B).
4. Connect the terminals of the windshield wiper motor connector as shown in the illustration (B).
5. Check to see that the windshield wiper motor runs at low speed and then stops at the automatic stop position.
