Lancer L4-2.0L SOHC (2004)
Front Door Panel: Technical Service Bulletins
Interior - Door Panel Vibration Noise
No: TSB-05-42A-002
DATE: January, 2005
MODEL: See below
SUBJECT:
DOOR PANEL VIBRATION NOISE
PURPOSE
Some vehicles may experience a vibration or rattling noise at the front door panels when the audio system is operating. This bulletin contains repair
information for eliminating vibration noise at the window control switches, door release handles, and grab handles. If the vibration noise seems to be
speaker- related, refer to TSB-04-54-002REV for audio speaker troubleshooting procedures.
Some vibration noises may be eliminated by using the felt material provided in the BSR kit listed in the PARTS INFORMATION section of this bulletin.
AFFECTED VEHICLES
2002-on Lancer and Lancer Sportback
PROCEDURE
1. Verify the specific noise complaint with the customer. Note the audio setting at which the noise occurs (volume, bass, treble, fader, and balance
control positions).
2. To determine the location of the noise, press a suspect area with your hand. The location is identified if the noise stops when you press it, and
starts again when you release.
a. If the noise seems to come from the window control switch, door release handle, or grab handle areas, go to Step 3.
b. If the noise is speaker-related, refer to TSB-04-54-002REV for audio speaker troubleshooting procedures.
3. After determining the location of the noise, use the appropriate repair procedure below:
a. Vibration at window switch may be caused by:
-
Window switch bezel lock tabs contacting the door panel.
The door panel fabric may be improperly positioned under the panel trim. This condition allows the bezel lock tabs to contact the trim
panel and causes the vibration noise.