Lancer L4-2.0L SOHC (2004)
STEP 19. Check the wiring harness between fog light relay connector A-04X (terminal 1) and combination meter connector C-01 (terminal 20).
NOTE: Also check intermediate connector C-129 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector C-129 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between fog light relay connector A-04X (terminal 1) and combination meter connector C-01 (terminal 20) in good condition?
YES: Replace the combination meter. Verify that the fog light indicator light illuminates normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the fog light indicator light illuminates normally.
Inspection Procedure L-1
Flasher Timer: Turn-signal lights does not flash when the turn-signal light switch is turned on.