Lancer L4-2.4L (4B12) (2009)
/Page-1197002.png)
Use a hexagon wrench to remove the stabilizer link and strut connection nut as shown in the figure.
INSTALLATION SERVICE POINT
]]A[[ STABILIZER LINK AND STRUT CONNECTION NUT INSTALLATION
Use a hexagon wrench to install the stabilizer link and strut connection nut as shown in the figure.
INSPECTION
^
Check for oil leaks from the strut assembly.
^
Check the strut assembly for damage or deformation.
Rear Suspension
SHOCK ABSORBER ASSEMBLY
REMOVAL AND INSTALLATION
CAUTION:
^
The parts indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb
weight condition.
^
The parts indicated by *2 are the bolts/nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and
soiling from the bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal & Post-installation Operation