Lancer L4-2.4L SOHC (2005)
2. Installation procedure
1. Use 3M(TM) AAD Part number 8906 or equivalent to clean the mark installation surfaces on the body.
CAUTION: When attaching the marks, the ambient temperature should be 20 - 38° C (60 - 100° F) and the air should be completely
free of dust. If the ambient temperature is lower than 20° C (60° F), the marks and the places on the vehicle body where the marks are
to be attached should be heated to 20 - 38° C (60 - 100° F).
2. Peel off the protection sheet on the back of the marks to affix it in position.