Lancer L4-2.4L SOHC (2005)
1. Loosen the nut of the generator pivot bolt.
2. Loosen the lock bolt.
3. Turn the adjusting bolt to adjust the belt vibration frequency, belt tension or deflection to the standard value.
CAUTION: Check after turning the crankshaft one or more rotations clockwise.
Standard value
4. Tighten the lock bolt.
Tightening torque: 23 ± 2 Nm (16 ± 2 ft. lbs.)
5. Tighten the nut of the generator pivot bolt.
Tightening torque: 44 ± 10 Nm (33 ± 7 ft. lbs.)
6. Tighten the adjusting bolt.
Tightening torque: 5.0 ± 1.0 Nm (44 ± 8 inch lbs.)
POWER STEERING OIL PUMP AND A/C COMPRESSOR DRIVE BELT TENSION CHECK AND ADJUSTMENT <2.0L ENGINE>
Check the drive belt tension by the following procedure.
<WHEN USING SCAN TOOL MB991958>
Required Special Tool:
^
MB991958: Scan Tool (MUT-III Sub Assembly)
^
MB991824: V.C.I.
^
MB991911: MUT-III Main Harness B
^
MB991668: Belt Tension Meter Set
Gently tap the middle of the belt between the pulleys (the location indicated by the arrow) with your finger as shown in the illustration, and check that
the vibration frequency of the belt is within the standard value.
NOTE: Refer to for details on the method of measuring the vibration frequency using the scan tool.
<WHEN USING A TENSION GAUGE>
