Lancer L4-2.4L SOHC (2005)
3. Measure the voltage between terminal 2 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 6.
NO: Go to Step 5.
STEP 5. Check the wiring harness between sunroof motor assembly connector D-32 (terminal 2) and ignition switch (IG2).
NOTE: Also check junction block connectors C-211 and C-218 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If
junction block connectors C-211 or C-218 are damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between sunroof motor assembly connector D-32 (terminal 2) and the ignition switch (IG2) in good condition?