Lancer L4-2.4L SOHC (2005)
STEP 6. Check the wiring harness from ETACS-ECU connectors C-226 (terminal 12), C-227 (terminal 22) and door lock actuator (front: LH)
connector E-04 (terminal 6 and 4).
NOTE: Also check junction block connector C-214 and intermediate connector C-17 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connector C-214 or intermediate connector C-17 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness from ETACS-ECU connectors C-226 (terminal 12), C-227 (terminal 22) and door lock actuator (front: LH) connector E-04
(terminal 6 and 4) in good condition?
YES: Replace the ETACS-ECU. Verify that the central door locking system works normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the central door locking system works normally.
Inspection Procedure C-2
Central Door Locking System: Some doors do not lock or unlock.