Lancer L4-2.4L SOHC (2005)
STEP 9. Check the wiring harness from ETACS-ECU connector C-226 (terminal 12 and 13) and door lock actuator (front: RH) connector E-15
(terminal 4 and 6).
NOTE: Also check junction block connector C-214 and intermediate connector C-110 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connector C-214 or intermediate connector C-110 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness from ETACS-ECU connector C-226 (terminal 12 and 13) and door lock actuator (front: RH) connector E-15 (terminal 4 and 6)
in good condition?
YES: Replace the ETACS-ECU. Verify that all the doors can be locked and unlocked normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that all the doors can be locked and unlocked normally.
STEP 10. Check door lock actuator (rear: LH) connector E-07 for loose, corroded or damaged terminals, or terminals pushed back in the
