Lancer L4-2.4L SOHC (2005)
2. Connect a battery to the motor terminal, and check that the motor runs freely.
Q: Is the power window motor (rear: RH) normal?
YES: Go to Step 26.
NO: Replace the rear power regulator assembly (RH). When the power window sub-switch (rear: RH) is operated, the rear power window (RH)
should open or close normally.
STEP 26. Check the battery power supply circuit to the power window sub-switch (rear: RH). Measure the voltage at power window
sub-switch (rear: RH) connector E-17.
1. Disconnect power window sub-switch (rear: RH) connector E-17 and measure the voltage available at the wiring harness side of the connector.
2. Turn the ignition switch to the "ON" position.
3. Measure the voltage between terminal 6 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 29.
NO: Go to Step 27.