Lancer L4-2.4L SOHC (2005)
Q: Does the windshield wiper motor operate normally?
YES: Go to Step 5.
NO: Replace the windshield wiper motor. Verify that the windshield wiper works normally.
STEP 5. Check the ground circuit to the windshield wiper motor. Measure the resistance at the windshield wiper motor connector B-01.
1. Disconnect windshield wiper motor connector B-01 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 5 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 7.
NO: Go to Step 6.
