Lancer L4-2.4L SOHC (2005)
STEP 9. Check the wiring harness between front-ECU connector A-11X (terminal 30) and the ignition switch (IG2).
NOTE: Also check intermediate connector C-129, junction block connectors C-210, C-211 and joint connector C-101 for loose, corroded, or damaged
terminals, or terminals pushed back in the connector. If intermediate connector C-129, junction block connectors C-210, C-211 or joint connector C-101
are damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between front-ECU connector A-11X (terminal 30) and the ignition switch (IG2) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the windshield wiper works normally.
Inspection Procedure G-2
Windshield Wiper and Washer: The windshield wipers do not work when the windshield wiper switch is at "INT" or "MIST" position or the
windshield washer switch is at "ON" position. However, the wipers work at low speed when the windshield wiper switch is at "LO" or "HI."