Lancer L4-2.4L SOHC (2005)
STEP 10. Check the wiring harness between combination meter connector C-01 (terminal 9) and the ignition switch (IG1).
NOTE: Also check junction block connectors C-211, C-214 and joint connector C-21 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connectors C-211, C-214 or joint connector C-21 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between combination meter connector C-01 (terminal 9) and the ignition switch (IG1) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the seat belt warning light illuminates normally.
STEP 11. Check combination meter connector C-02 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connector C-228 in good condition?
YES: Go to Step 12.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the seat belt warning light illuminates normally.
