Lancer L4-2.4L SOHC (2005)
component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between license plate light (LH) connector F-11 (terminal 2) and front-ECU connector A-10X (terminal 8) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the license plate lights illuminate normally.
STEP 35. Check license plate light (LH) connector F-11 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is license plate light (LH) connector F-11 in good condition?
YES: Go to Step 36.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the license plate lights (LH) illuminate
normally.
STEP 36. Check the license plate light bulb (LH).
1. Remove the license plate light bulb (LH).
2. Verify that the license plate light bulb (LH) is not damaged or burned out.
Q: Is the license plate light bulb (LH) in good condition?
YES: Go to Step 37.
NO: Replace the license plate light bulb (LH). Verify that the license plate lights illuminate normally.
STEP 37. Check the ground circuit to the license plate light (LH). Measure the resistance at license plate light (LH) connector F-11.
1. Disconnect license plate light (LH) connector F-11 and measure the resistance available at the wiring harness side of the connector.
