Lancer L4-2.4L SOHC (2005)
3. Connect terminal 72 to ground.
Q: Does the high-beam indicator light illuminate?
YES: Replace the ETACS-ECU. Verify that the high-beam indicator light illuminates normally.
NO: Go to Step 4
STEP 4. Check combination meter connector C-01 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is combination meter connector C-01 in good condition?
YES: Go to Step 5.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the high-beam indicator light illuminates
normally.
STEP 5. Check high-beam indicator light bulb.
1. Remove the high-beam indicator light bulb.
2. Verify that the high-beam indicator light bulb is not damaged or burned out.
Q: Is the high-beam indicator light normal?
YES: Go to Step 6
NO: Replace the bulb. Verify that the high-beam indicator light illuminates normally.
STEP 6. Check the combination meter (printed-circuit board).