Lancer L4-2.4L SOHC (2005)
Front turn-signal light (LH) and side turn-signal light (LH) : Go to Step 2.
Front turn-signal light (RH) and side turn-signal light (RH) : Go to Step 4.
front turn-signal light (LH) : Go to Step 6.
front turn-signal light (RH) : Go to Step 12.
side turn-signal light (LH) : Go to Step 18.
side turn-signal light (RH) : Go to Step 24.
rear combination light (LH) : Go to Step 30.
rear combination light (RH) : Go to Step 36.
combination meter (LH) : Go to Step 42.
combination meter (RH) : Go to Step 44.
Combination meter (both right and left) : Go to Step 46
front turn-signal light (RH), side turn-signal light (RH) and rear combination light (RH) : Go to Step 48.
LH side only : Refer to Inspection Procedure K-1 "Turn-signal lights does not flash when the turn-signal light switch is turned on."
RH side only : Refer to Inspection Procedure K-1 "Turn-signal lights does not flash when the turn-signal light switch is turned on."
Both LH and RH sides : Refer to Inspection Procedure K-2 "Hazard warning light does not illuminate."
STEP 2. Check front turn-signal light (LH) connector A-16 and ETACS-ECU connector C-226 for loose, corroded or damaged terminals, or
terminals pushed back in the connector.
Q: Are front turn-signal light (LH) connector A-16 and ETACS-ECU connector C-226 in good condition?
YES: Go to Step 3.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.