Lancer L4-2.4L SOHC (2005)
STEP 23. Check the wiring harness between side turn-signal light (LH) connector A-02 (terminal 2) and ETACS-ECU connector C-226
(terminal 14).
NOTE: Also check junction block connector C-210 and intermediate connector C-129 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connector C-210 or intermediate connector C-129 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between side turn-signal light (LH) connector A-02 (terminal 2) and ETACS-ECU connector C-226 (terminal 14) in good
condition?
YES: Replace the socket. Verify that the turn-signal lights illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
STEP 24. Check side turn-signal light (RH) connector A-01 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q: Is the side turn-signal light (RH) connector A-01 in good condition?
YES: Go to Step 25.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.
Part 2 of 2
STEP 25. Check the side turn-signal light bulb (RH).
1. Remove the side turn-signal light (RH) bulb.
2. Verify that the side turn-signal light bulb (RH) is not damaged or burned out.
Q: Is the side turn-signal light (RH) bulb in good condition?
YES: Go to Step 26.
NO: Replace the side turn-signal light (RH) bulb. Verify that the turn-signal lights illuminate normally.
STEP 26. Check the ground circuit to the side turn-signal light (RH). Measure the resistance at side turn-signal light (RH) connector A-01.
