Lancer L4-2.4L SOHC (2005)
STEP 41. Check the wiring harness between rear combination light (RH) connector F-08 (terminal 1) and ETACS-ECU connector C-226
(terminal 9).
NOTE: Also check junction block connector C-210 and intermediate connector C-113 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connector C-210 or intermediate connector C-113 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between rear combination light (RH) connector F-08 (terminal 1) and ETACS-ECU connector C-226 (terminal 9) in good
condition?
YES: Replace the socket assembly. Verify that the turn-signal lights illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.