Lancer L4-2.4L SOHC (2005)
YES: Go to Step 47.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.
STEP 47. Check the wiring harness between combination meter connector C-02 (terminal 48) and ground.
Q: Is the wiring harness between combination meter connector C-02 (terminal 48) and ground in good condition?
YES: Replace the combination meter. Verify that the turn-signal lights illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
STEP 48. Check front turn-signal light (RH) connector A-20 and ETACS-ECU connector C-226 for loose, corroded or damaged terminals, or
terminals pushed back in the connector.
Q: Are front turn-signal light (RH) connector A-20 and ETACS-ECU connector C-226 in good condition?
YES: Go to Step 49.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.