mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 1997 > < Initial Inspection and Diagnostic Overview|Page 1995
Page 323
background image

The ETACS-ECU operates the dome light according to the following signals:

-

Ignition switch (IG1)

-

Key reminder switch

-

Door switch (front: LH)

-

All door switches

-

Door lock actuator switch (front: LH)

TECHNICAL DESCRIPTION (COMMENT)

Is the dome light does not flash normally, a burned-out dome light bulb, the input circuits from the switches described in "CIRCUIT OPERATION", the
power supply line to the switches or the ETACS-ECU may be defective. Alternatively, the delay-off function may be set to "0 second" by using the
configuration function.

TROUBLESHOOTING HINTS

-

The key reminder switch may be defective

-

The door switch may be defective

-

The driver's door lock actuator switch may be defective

-

The dome light may be defective

-

The ETACS-ECU may be defective

-

The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector

DIAGNOSIS

Required Special Tools:

-

MB991223: Harness Set

-

MB991958: Scan Tool (MUT-III Sub Assembly)
-

MB991824: Vehicle Communication Interface (V.C.I.)

-

MB991827: MUT-III USB Cable

-

MB991911: MUT-III Main Harness B

STEP 1. Verify which of the front dome light, the rear dome light <vehicles without sunroof> or the luggage compartment light does not
illuminate normally
.

Q: Which of the front dome light, the rear dome light <vehicles without sunroof> or the luggage compartment light fail to illuminate normally?

Front dome light does not illuminate normally : Go to Step 2.

rear dome Light <vehicles without sunroof> : Go to Step 8.

luggage compartment light : Go to Step 14.

STEP 2. Check front dome light connectors D-05 for loose, corroded or damaged terminals, or terminals pushed back in the connector.

Q: Is front dome light connector D-05 in good condition?

YES: Go to Step 3.

NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the front dome light illuminates normally.

STEP 3. Verify the front dome light bulb.

Q: Is the front dome light bulb in good condition?

Initial Inspection and Diagnostic Overview|Page 1997 > < Initial Inspection and Diagnostic Overview|Page 1995