Lancer L4-2.4L SOHC (2005)
NO: Replace the bulb. Verify that the luggage compartment lights illuminate normally.
STEP 16. Check the battery power supply circuit to the luggage compartment light. Measure the voltage at luggage compartment light F-02.
1. Disconnect luggage compartment light F-02 and measure the voltage available at the harness side of the connector.
2. Measure the voltage between terminal 1 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 19.
NO: Go to Step 17.
STEP 17. Check ETACS-ECU connector C-226 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is ETACS-ECU connector C-226 in good condition?
YES: Go to Step 18.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the luggage compartment lights illuminate
normally.
