Lancer L4-2.4L SOHC (2005)
receive any signal from all the door switches."
When one of the interior lights is illuminated, scan tool MB991958 does not sound : Refer to Inspection Procedure N-10 "ETACS-ECU does
not receive any interior light loaded signal."
Inspection Procedure L-4
Interior Light: The interior light automatic shut-down function does not work normally.
Interior Light Automatic Shut-down Function Circuit
CIRCUIT OPERATION
The ETACS-ECU operates the interior light automatic shutdown function according to the following switch signals:
-
Ignition switch (ACC)
-
Ignition switch (IG1)
-
Door switch (front: LH)
-
All door switches
-
Interior light loaded signal.
TECHNICAL DESCRIPTION (COMMENT)
If the function does not work normally, the input circuit system from the switches or the ETACS-ECU may be defective (refer to "CIRCUIT
OPERATION").
TROUBLESHOOTING HINTS
-
The door switch may be defective
-
The ETACS-ECU may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tools:
-
MB991223: Harness Set
-
MB991958: Scan Tool (MUT-III Sub Assembly)
