Lancer L4-2.4L SOHC (2005)
STEP 8. Check combination meter connector C-02 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is combination meter connector C-02 in good condition?
YES: Go to Step 9.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the door ajar indicator light illuminates
normally.
STEP 9. Check the wiring harness between combination meter connector C-02 (terminal 34) and ETACS-ECU connector C-228 (terminal 53).
Q: Is the wiring harness between combination meter connector C-02 (terminal 34) and ETACS-ECU connector C-228 (terminal 53) in good condition?
YES: Replace the ETACS-ECU. Verify that the door ajar indicator light illuminates normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the door ajar indicator light illuminates normally.
Inspection Procedure M-1
The ETACS-ECU does not receive any signal from the ignition switch (ACC).
