Lancer L4-2.4L SOHC (2005)
STEP 3. Check the wiring harness between ETACS-ECU connector C-226 (terminal 8) and the ignition switch (IG1).
NOTE: Also check junction block connector C-211 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If junction
block connector C-211 is damaged, Repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector C-226 (terminal 8) and ignition switch (IG1) in good condition?
YES: No action is necessary and testing is complete.
NO: Replace the ETACS-ECU. If the functions, which are described in "CIRCUIT OPERATION", work normally, the input signal from the ignition
switch (IG1) should be normal.
Inspection Procedure M-3
ETACS-ECU does not receive "R" position signal from the transmission range switch <A/T>.