Lancer L4-2.4L SOHC (2005)
STEP 2. Check sunroof motor assembly connector D-32 and ETACS-ECU connector C-228 for loose, corroded or damaged terminals, or
terminals pushed back in the connector.
Q: Are sunroof motor assembly connector D-32 and ETACS-ECU connector C-228 in good condition?
YES: Go to Step 3.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. If the sunroof operates normally, it indicates that a correct
signal is sent from the sunroof switch.
STEP 3. Check the wiring harness between sunroof motor assembly connector D-32 (terminal 10) and ETACS-ECU connector C-228 (terminal
59).
NOTE: Also check intermediate connector C-18 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector C-18 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.