mitsubishi Workshop Repair Guides

Mitsubishi Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2074 > < Initial Inspection and Diagnostic Overview|Page 2072
Page 400
background image

STEP 5. Check ETACS-ECU connector C-227 for loose, corroded or damaged terminals, or terminals pushed back in the connector.

Q: Is ETACS-ECU connector C-227 in good condition?

YES: Go to Step 6.

NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. If the rear wiper operates normally, it indicates that a
correct "R" position signal is sent from the backup light switch.

Initial Inspection and Diagnostic Overview|Page 2074 > < Initial Inspection and Diagnostic Overview|Page 2072