Lancer L4-2.4L SOHC (2005)
1. Disconnect power window main switch connector E-05 and measure the resistance available at the wiring harness side of the connector.
2. Measure the resistance value between terminal 8 and ground.
-
The resistance should equal 2 ohms or less.
Q: Is the measured resistance 2 ohms or less?
YES: Go to Step 6.
NO: Go to Step 5.
STEP 5. Check the wiring harness between power window main switch E-05 (terminal 8) and ground.
NOTE: Also check intermediate connector C-17 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If intermediate
connector C-17 is damaged, repair or replace the damaged component(s) as described in Harness Connector Inspection.