Lancer L4-2.4L SOHC (2005)
STEP 7. Check the wiring harness between ETACS-ECU connector C-226 (terminal 4) and the ignition switch (ACC).
NOTE: Also check junction block connector C-210, joint connector C-101 and intermediate connector C-129 for loose, corroded, or damaged
terminals, or terminals pushed back in the connector. If junction block connector C-210, joint connector C-101 or intermediate connector C-129 are
damaged, Repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector C-226 (terminal 4) and ignition switch (ACC) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the functions or equipment, which are described in "CIRCUIT OPERATION", work normally,
the interior light loaded signal should be normal.