Lancer L4-2.4L SOHC (2005)
Check the following ECUs:
-
ETACS-ECU
-
Column-ECU
CAUTION: To prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or
disconnecting scan tool MB991958. Connect the DLC harness before connecting the column-ECU harness. Be sure to connect SWS monitor kit
MB991813 after turning on scan tool MB991958.
1. Connect scan tool MB991958 to the data link connector.
2. Connect SWS monitor kit MB991813 to the column switch connector.
3. Turn the ignition switch to the "LOCK" (OFF) position.
4. Operate scan tool MB991958 according to the procedure below to display "ECU COMM CHK."
a. Select "SYSTEM SELECT.
b. Select "SWS.
c. Select "SWS MONITOR.
d. Select "ECU COMM CHK.
5. Scan tool MB991958 should show "OK" on the "ECU COMM CHK" menus for both the "ETACS ECU" and the "COLUMN ECU" menus.
Q: Are "OK" displayed on both the "ETACS ECU" and "COLUMN ECU" menus?
"OK" are displayed for all the items: . Go to Step 2.
"NG" is displayed on the "COLUMN ECU" menu: . Go to Step 6.
"NG" is displayed on the "ETACS ECU" menu: . Refer to Inspection Procedure A-3 "Communication with ETACS-ECU is not possible."
"NG" are displayed for all the items: . Refer to Inspection Procedure A-3 "Communication with ETACS-ECU is not possible."
