Lancer L4-2.4L SOHC (2005)
STEP 1. Check sunroof motor assembly connector D-32 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is sunroof motor assembly connector D-32 in good condition?
YES: Go to Step 2.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. The system should communicate with the sunroof motor
assembly (sunroof-ECU) normally.
STEP 2. Check the fusible link (5) line of power supply circuit to the sunroof motor assembly. Measure the voltage at sunroof motor assembly
connector D-32.
1. Disconnect sunroof motor assembly connector D-32 and measure the voltage available at the wiring harness side of the connector.
2. Measure the voltage between terminal 1 and ground.
-
The voltage should equal approximately 12 volts (battery positive voltage).
Q: Is the measured voltage approximately 12 volts (battery positive voltage)?
YES: Go to Step 4.
NO: Go to Step 3.