Lancer L4-2.4L SOHC (2005)
STEP 17. Check the wiring harness from ETACS-ECU connector C-226 (terminal 12 and 13) and door lock actuator (rear: RH) connector
E-18 (terminal 3 and 2).
NOTE: Also check junction block connector C-214, intermediate connectors C-113 and D-04 for loose, corroded, or damaged terminals, or terminals
pushed back in the connector. If junction block connector C-214, intermediate connectors C-113 or D-04 are damaged, repair or replace the connector as
described in Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector C-226 (terminal 12 and 13) and door lock actuator (rear: RH) connector E-18 (terminal 3 and
2) in good condition?
YES: Replace the ETACS-ECU. Verify that all the doors can be locked and unlocked normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that all the doors can be locked and unlocked normally.
Inspection Procedure C-3
Central Door Locking System: All the doors do not lock or unlock with just the door lock switch operation.
