Lancer L4-2.4L SOHC (2005)
STEP 5. Check the wiring harness between rear combination light assembly (RH) connector F-08 (terminal 3) and front-ECU connector A-10X
(terminal 8).
NOTE: Also check joint connector C-05, intermediate connectors C-111 and C-129 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If joint connector C-05, intermediate connectors C-111 or C-129 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between position light (RH) connector F-08 (terminal 3) and front-ECU connector A-10X (terminal 8) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. The position light (RH) and the taillight (RH) should illuminate normally.
STEP 6. Check position light (LH) connector A-14 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
