Lancer L4-2.4L SOHC (2005)
STEP 29. Check the wiring harness between rear combination (RH) connector F-08 (terminal 3) and front-ECU connector A-10X (terminal 8).
NOTE: Also check intermediate connectors C-113, C-129 and joint connector C-05 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If intermediate connectors C-113, C-129 or joint connector C-05 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between rear combination light (RH) connector F-08 (terminal 3) and front-ECU connector A-10X (terminal 8) in good
condition?
YES: Replace the rear light socket (RH). Verify that the taillight (RH) illuminates normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the taillight (RH) illuminates normally.
STEP 30. Check the ground circuit to the license plate light (LH). Measure the resistance at license plate light (LH) connector F-11.
