Lancer L4-2.4L SOHC (2005)
Headlights Circuit Part 2
TECHNICAL DESCRIPTION (COMMENT)
If one of the headlights does not illuminate, a head- light bulb may be defective.
TROUBLESHOOTING HINTS
-
The headlight bulb may be defective
-
The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
DIAGNOSIS
Required Special Tool:
-
MB991223: Harness Set
STEP1. Check the headlight operation.
Q: Which of the headlights does not illuminate?
LH (low and high beam) : Go to Step 2.
RH (low and high beam) : Go to Step 5.
LH (only low-beam) : Go to Step 8.
RH (only low-beam) : Go to Step 12.
LH (only high beam) : Go to Step 16.
RH (only high beam) : Go to Step 20.
Low beam only (both RH and LH) : Refer to Inspection Procedure I-2 "Headlights (low-beam) do not illuminate."
High beam (both RH and LH) and high-beam indicator light : Refer to Inspection Procedure I-3 "Headlights (high-beam) do not illuminate."
Only high-beam indicator light : Refer to Inspection Procedure I-8 "The high-beam indicator light does not illuminate."
STEP 2. Check headlight (LH) connector A-15 for loose, corroded or damaged terminals, or terminals pushed back in the connector.
Q: Is headlight (LH) connector A-15 in good condition?
YES: Go to Step 3.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the headlights illuminate normally.