Lancer L4-2.4L SOHC (2005)
STEP 3. Check the wiring harness between front turn-signal light (LH) connector A-16 (terminal 2) and ETACS-ECU connector C-226
(terminal 14).
NOTE: Also check intermediate connector C-129 and junction block connector C-210 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If intermediate connector C-129 or junction block connector C-210 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between front turn-signal light (LH) connector A-16 (terminal 2) and ETACS-ECU connector C-226 (terminal 14) in good
condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
