Lancer L4-2.4L SOHC (2005)
STEP 5. Check the wiring harness between front turn-signal light (RH) connector A-20 (terminal 2) and ETACS-ECU connector C-226
(terminal 9).
NOTE: Also check junction block connector C-210 and intermediate connector C-111 for loose, corroded, or damaged terminals, or terminals pushed
back in the connector. If junction block connector C-210 or intermediate connector C-111 are damaged, repair or replace the damaged component(s) as
described in Harness Connector Inspection.
Q: Is the wiring harness between front turn-signal light (RH) connector A-20 (terminal 2) and ETACS-ECU connector C-226 (terminal 9) in good
condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
STEP 6. Check front turn-signal light (LH) connector A-16 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q: Is the front turn-signal (LH) connector A-16 in good condition?
YES: Go to Step 7.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.
STEP 7. Check the front turn-signal light bulb (LH).
1. Remove the front turn-signal (LH) light bulb.
2. Verify that the front turn-signal light bulb (LH) is not damaged or burned out.
Q: Is the front turn-signal (LH) light bulb in good condition?
YES: Go to Step 8.
NO: Replace the front turn-signal (LH) light bulb. Verify that the turn-signal lights illuminate normally.
STEP 8. Check the ground circuit to the front turn signal light (LH). Measure the resistance at front turn-signal light (LH) connector A-16.
