Lancer L4-2.4L SOHC (2005)
condition?
YES: Replace the socket assembly. Verify that the turn-signal lights illuminate normally.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. Verify that the turn-signal lights illuminate normally.
STEP 36. Check rear combination light (RH) connector F-08 for loose, corroded or damaged terminals, or terminals pushed back in the
connector.
Q: Is rear combination light (RH) connector F-08 in good condition?
YES: Go to Step 37.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. Verify that the turn-signal lights illuminate normally.
STEP 37. Check the rear turn-signal light bulb (RH).
1. Remove the rear turn-signal light bulb (RH).
2. Verify that the rear turn-signal light bulb (RH) is not damaged or burned out.
Q: Is the rear turn-signal light bulb (RH) in good condition?
YES: Go to Step 38.
NO: Replace the rear turn-signal (RH) light bulb. Verify that the turn-signal lights illuminate normally.
STEP 38. Check the ground circuit to the rear turn-signal light (RH). Measure the resistance at rear combination light (RH) connector F-08.
1. Disconnect rear combination light (LH) connector F-08 and measure the resistance available at the wiring harness side of the connector.
