Lancer L4-2.4L SOHC (2005)
STEP 3. Check the wiring harness between ETACS-ECU connector C-226 (terminal 18) and the ignition switch (ACC).
NOTE: Also check junction block connector C-211 for loose, corroded, or damaged terminals, or terminals pushed back in the connector. If junction
block connector C-211 is damaged, Repair or replace the damaged component(s) as described in Harness Connector Inspection.
Q: Is the wiring harness between ETACS-ECU connector C-226 (terminal 18) and ignition switch (ACC) in good condition?
YES: No action is necessary and testing is complete.
NO: The wiring harness may be damaged or the connector(s) may have loose, corroded or damaged terminals, or terminals pushed back in the
connector. Repair the wiring harness as necessary. If the equipment, which are described in "CIRCUIT OPERATION", work normally, the input
signal from the ignition switch (ACC) should be normal.
Inspection Procedure M-2
The ETACS-ECU does not receive any signal from the ignition switch (IG1).
