Lancer L4-2.4L SOHC (2005)
STEP 3. Check column switch connector C-206 and ETACS-ECU connector C-228 for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Are column switch connector C-206 and ETACS-ECU connector C-228 in good condition?
YES: Go to Step 4.
NO: Repair or replace the damaged component(s). Refer to Harness Connector Inspection. If the wiper interval can be adjusted normally, it indicates
that the windshield intermittent wiper interval adjusting knob should send a signal to the ECU.
STEP 4. Check the wiring harness between column switch connector C-206 (terminal 6) and ETACS-ECU connector C-228 (terminal 66).
Q: Is the wiring harness between column switch connector C-206 (terminal 6) and ETACS-ECU connector C-228 (terminal 66) in good condition?